Description The TBS Lucid H7 Flight Controller is a powerhouse built for those who crave peak performance and adaptability in their drones. Whether you’re ripping through freestyle moves or fine-tuning a racing rig, the TBS Lucid H7 delivers with its robust 480MHz processor and seamless support for Betaflight, ArduPilot, and INAV. Featuring dual camera inputs, DJI FPV OSD compatibility, and a compact design, it fits effortlessly into any setup. Designed for both seasoned pros and enthusiastic newcomers, this flight controller makes pushing the limits of your drone easier than ever. Specifications: MCU: STM32H743VIH6 running at 480MHz, with 1MB RAM and 2MB Flash. Gyro: ICM42688 x 2 (duo gyro) OSD Chip: AT7456E (SPI2) Barometer: Infineon DPS310 connected via I2C2. PWM Outputs: 13 channels, including a dedicated “LED” pad. Blackbox (BB): Data logging equipped with a MicroSD card slot (SDIO) UARTs: 7 total (1, 2, 3, 4, 6, 7, 8) signal inversion ready I2C Buses: 2 available. CAN Bus: 1 available. Analog Inputs: 6 ADC channels (VBAT, Current, RSSI, Analog AirSpeed, Vbat2, Cur2). LED Indicators: 3 LEDs (Blue, Green for FC Status, Red for 3.3V Power). Breakout: SPI3 breakout available. USB Interface: Type-C connector (USB 2.0 standard). JST Connectors: 1x JST-SH1.0 8-pin (Vbat/G/Curr/Rx8/S1/S2/S3/S4) 1x JST-GH1.25 4-pin (5V/CAN-H/CAN-L/Ground). Dual Camera Input: Switchable inputs for two cameras. Power Control: Switch for filtered 5V/Vbat output power. DJI FPV OSD: Compatible via any spare UART port. Power Specifications: Input Voltage: 6 – 36V (2 to 8S LiPo). BEC: 5V 2A continuous (3A max) & 9V 2A continuous (3A max) LDO 3.3V: Supports up to 200mA. Voltage Support: ADC Vbat2 pad supports up to 36V (1K:10K voltage divider). Power Consumption: 200mA @ 5V with Betaflight, 150mA @ 5V with ArduPilot. FC Firmware Targets: ArduPilot: TBS_LUCID_H7 BetaFlight: TBS_LUCID_H7 INAV: TBS LUCID_H7 Package Includes: TBS Lucid H7 FC FC-to-ESC cable (plug & play) DJI O3 cable (plug & play) 4 x M3 rubber dampers 4 x M3x8 screws
